While the Squadron putty was drying I cut the nose of an ESCI FFAR pod:
and inserted the base into the inlet of the APU to give it some detail.
Here’s how the outcome looks before paint:
The amount of putty required and the sanding is obvious on the series of pictures above, but let me tell you – this is a great stress-relief technique.
I also created a new gun mount to replace the missing part, using brass barrels of a design closest to the original GSh-30. These are fixed into a block of laminated styrene. The white brackets are scrap styrene sheet.
I built this kit for a group build in April this year. My goal was to finish the build in the shortest time possible – it was intended as a kickstart after for quite some time I did not finish a kit.
The basic airframe used has been an ancient ESCI release which I bought dirt-cheap from a guy that regularly renews his collection. He had used certain parts from the kit, the gunpack included, so I was up for some scratchbuilding fun.
I started with the cargo hold doors, which were rather thick. I had to thin them around the edges in order for them to fit.
After so much waiting the new Mi-24 by Zvezda is finally in my hands. Probably one of the most awaited models in the 72nd scale, this impressive offering has no less than 284 parts and allows you to build the most accurate “Crocodile” in the scale to date.
One of the perks you get with the kit is the complete engine/gearbox setup that allows you to build your Hind all opened up (you’d still need to make the compartment plumbing yourself or wait for Eduard’s go at it though). Pick a V version with the YakB-12,7 Gatling gun, or a GSh-23-2 armed VP. Hang some serious firepower under the wings, pop the two pilots in the cockpits and let it rip!